If a new broadband is installed, I will give you specific installation and setting methods:

1. Connect the telephone line to the DSL port of the cat, connect the Ethernet port of the cat to the WAN port of the router with the network cable, and connect any LAN port of the router to the network card port of the computer with the network cable (the wireless network card cannot enter the router). After the connection is completed, it can be powered on.

2. Turn on the computer and set the IP to automatic acquisition (the system defaults to automatic, which can be ignored without modification). Then open a browser and enter the address of the router (as described in the admin router manual), such as 192. 168. 1 enter. The user name and password of the router will be displayed, and you can enter the router after input.

Password Manager (case-sensitive)

3. After entering the general router, there will be a display setting direction to guide you how to set up the router quickly. There are mainly the following points: set the dialing mode, select PPPOE, and enter the broadband account and password (pay attention to case sensitivity). If you use a wireless router, you will continue to set the SSID (the name of the wireless router, but not the Chinese name) and the wireless link password (about 8 digits or more). Other default settings are also possible. Mainly around these points.

If a network cable comes from someone else's router, you should set up your own router.