① Before using the loader, the driver and relevant personnel must carefully read the operation and maintenance manual or operation and maintenance manual provided by the manufacturing enterprise, and operate according to the matters specified in the data. Otherwise, it will bring serious consequences and unnecessary losses.
(2) The driver shall meet the safety requirements and wear necessary protective facilities.
(3) In the narrow or dangerous area of the operation area, warning signs must be set within its scope or at dangerous points.
④ It is absolutely forbidden for drivers to work under the influence of alcohol or excessive fatigue.
⑤ When carrying out maintenance or inspection work in the central hinge area, an "anti-rotation bar" should be installed to prevent the front and rear frames from rotating relatively.
6. After the loader stops, get up and down the loader where there are stair handrails. Don't jump up and down when the loader is working or walking.
⑦ When the loader needs to be lifted for maintenance, the lifted boom must be firmly padded to ensure that the boom will not fall under any maintenance conditions.
2. Safety precautions before starting the engine
① Check and ensure that the lighting of all lamps and all display lamps can be displayed normally. In particular, it is necessary to check whether the turn signals and brake display lights are normal.
② Check and ensure that no one is allowed to work under the vehicle or near the loader when starting the engine, so as to ensure that the safety of himself or others will not be endangered in case of an accident.
(3) Before starting the loader, pull the speed control handle to the neutral position.
④ For the braking system without emergency braking, put the hand brake handle plate in the parking position.
⑤ Start or run the engine only where there is air circulation. When operating indoors, connect the exhaust port of the engine to the outside or face the outside.
3. Safety precautions after starting the engine and during operation
① After the engine is started, wait until the braking air pressure reaches the safe air pressure before preparing to start, so as to ensure the braking safety when driving. If there is emergency braking, press the button of the emergency and parking brake valve (only when the air pressure reaches the allowable starting air pressure, the button can be pressed, otherwise it will automatically jump up), so that the emergency and parking brake can be released, and then it can be started in gear I.. If there is no emergency braking, just put down the parking brake handle and release the parking brake to start.
(2) Remove the faults of the loader in the aisle, and pay special attention to obstacles such as iron blocks and ditches to avoid cutting the tires.
③ Adjust the rearview mirror to make the driver have the best view after sitting.
④ Ensure that the horn, rear signal lamp and all safety devices of the loader can work normally.
⑤ When you are about to start or check whether the steering is flexible, you should honk your horn first to warn people around you to pay attention to safety.
⑥ Before starting to walk, all joysticks, pedals and steering wheels should be tried once, and then work should be started after being confirmed to be in normal condition. Pay special attention to check whether the steering and braking are good. Before starting the operation, ensure that the steering and braking are completely normal.
⑦ When driving, place the bucket at a height of about 400 mm from the ground. When working on mountain slopes or crossing ditches and other obstacles, you should slow down and turn over slightly. When the loading surface begins to slide to one side on a steep slope, it must be unloaded immediately to prevent further slide.
⑧ Try to avoid too many tires and excessive skidding when working; Try to avoid two wheels hanging in the air, and it is not allowed to continue working with only two wheels touching the ground.
Pet-name ruby as a tractor, only allowed to hitch with the traction device, people are not allowed to stand between the towed object and the loader, and keep a safe distance to prevent safety accidents.