1, semi-trailer gear two-foot separation method, two-foot clutch is to step on one foot when selecting gear and step on one foot when entering gear, and the speed and speed are reasonable.

2, one-foot separation method, one-foot clutch means that you don't have to clutch when you pick up the gear, and you have to step on the clutch when you enter the gear. This method needs to be practiced without clutch. Why do you want to use this method, because if you use one foot to clutch at the same time, the gear is easy to make a noise. Of course, there are also quiet masters, but very few.

3, no clutch plate method, this method is also to practice without clutch gear, when hanging, wait until the engine sound is almost over and then rush into gear, that is, when the speed drops to the lowest speed.

4. The shift is consistent with the speed; It should be noted that after getting on the bus, it is necessary to adjust the width and simplicity of the seat, detect the angle of the rearview mirror and fasten the seat belt.

5. After starting the car, be sure to start in gear and coordinate the oil distribution. Only in this way can you start steadily. Subject three is taboo, don't jump gears. In the exam, when you have to change gears, you must change gears step by step. During the whole driving process, always keep your eyes on the front, even if you want to shift gears, keep your eyes on the front.

6. When it is necessary to shift gears, release the accelerator of the right foot. After the speed is stable, the left foot will be detached. At this time, the right hand will shift gears in time, and the left hand will always hold the steering wheel tightly. It should be said that the shift operation requires very high coordination between hands and feet, so we must master the order skillfully. When you want to add a wax block, you should accelerate the refueling when you add a block, and then shift to a high gear. Instead, slow down and shift to a lower gear.