Remember to save the picture with a screenshot first, so that you can recover it when something goes wrong in the future.
Use the browser's view source function to view the source code. Then, search for your user name. When found, the next line is the password. The password in this "single quotation mark" is encrypted with base64. After copying, it is decoded by online base64 in Baidu application, and the result is your pppoe password. Remember to write it down and save it with your user name. (You should record the MTU value, which will be useful later.)
After completing the above steps, click "Delete" in the lower right corner.
Then in the connection name, you will automatically go to' new connection name', directly select' bridge' as the mode, bind port 4 (the port bound when the target bridge routes the network cable), select UNTAG of VLAN, not DHCP, and finally, create. At this time, the Internet _? _vid setting, check it, and you will find that it is consistent with the bridge you set.
"Network"-"Local Area Network Address Management", cancel DHCP. Save and exit.
Enter the ip address of the destination route (here refers to the external router), select pppoe for the wan port, and you already have the user name and password. Fill it out, remember to select "automatic connection, automatic connection after starting disconnection". Remember to save. Don't restart yet.
The access line is connected to the WAN port of the router. Plug in a LAN port on your computer.
Set the local area network port, and the routing ip address is 192. 168. 1 .2. Turn on the router DHCP, and the DHCP address segment will avoid192.168.1and/kloc-0. Remember to restart the light cat F420 at the same time. (MTU value has been set) (just plug in the power supply)
Wait about 30 seconds and check the Wan status in the routing status. The sign of pppoe dialing success is as follows:
IP address: XXX. XXX.XXX.243 PPPoE automatic connection.
Subnet mask: 255.255.255.255?
Gateway: XXX. XXX.XX.243？
DNS server: xxx.xxx.xxx. 1 18, xxx.xxx. 18.
Detection: the computer connects to the routing and turns on BT. Check the lower right corner to see if it is green. If the light is green, it means success.
Turn off firewall settings when opening ports, and whether to ignore these settings when ping wan ports.
Supplementary contents (2012-2-1313: 38):
The ip address of the LAN port of the bridge router may not be in the same network segment as the optical cat, such as 192 438+068.0.
However, the port forwarding of the bridge router must set the ports of BT and emule, and the computer client must use the static ip address, otherwise it will still encounter the problem of port closure.