Generally, there will be a QR code of related software on the camera package, which can be configured by scanning. The second method is to set it with special setting software. This manufacturer will not give it to you, and some apps of QR code may not be set.

How to get the IP address of the camera

Is there any software available?

1. Install according to the instruction manual or quick installation guide. Among them, there is IPCamSearch tool in the CD-ROM of the network camera, and IP address and port are assigned to the network camera according to the search tool;

2. Put the matched CD into the computer CD-ROM drive, run the IPCamSearch tool, and an interface will appear;

3. The interface displays all the IP searched in the current LAN.

Product serial number, current IP address and firmware version of the camera;

4. if IP

The camera and the computer used are not on the same network segment, so they cannot access each other through. For example, if the IP of the computer is192.168.100.33 and the subnet mask is 255.255.255.0, then the IP address segment that the computer can access is192.168.63.

The IP address of the camera is not within this range, so the computer cannot directly access it;

5. At this point, you can click "Set IP Address" to select IP.

The camera is set;

6. The ip setting software of different cameras will be different. After setting it up, you can watch it.

7. If you want to realize remote viewing, you need to set port mapping and input the information set above into the "Virtual Server Page". After the setting is successful, you can watch it remotely.