Mine is Ruijie 3.95, but it should be about the same ~ The campus network doesn't need a converter. If you want to surf the Internet wirelessly, you need to buy a wireless router first. I use Mercury 54M, which makes me feel good. Take my router settings as an example. First, make sure that the wireless router is connected correctly and that the network cable is plugged into a WAN port (not a LAN port). You don't need to modify the ip properties of the wireless network card, just don't worry (that is, don't set the IP gateway mask like setting a local connection) to make sure that the computer has searched your network and connected. Then open IE

Enter "http:/192.168.1"in the IE address bar, and then a dialog box will pop up, where you can enter your user name and password (admin by default).

The education network (campus network) chooses static IP and Ethernet broadband.

Set the network name and so on, and then until the setting is completed, the most important thing is the next step.

Select network parameter-mac address clone, and fill in the column of "mac address" the physical address you used to pass through the wired network card, that is, the physical address (MAC address) you filled in when you applied for Internet access. The currently managed MAC address is the physical address of my wireless network card, and the one above is the physical address of my wired network card.

This will probably do, then open Ruijie, select your wireless network card, fill in the user name and password, and connect. If you don't have the iron MAC address on the MAC clone, you may be reminded that the physical address is bound incorrectly at this time.

Now that the route has been set up, it's time to make the final minor changes. Because the campus network does not support * * *, your wireless route can only be bound with a static IP, and the LAN port of the wireless router is connected to the network interface of the computer with a network cable. Remember which interface of LAN is not WAN! ! Enter the WEB management page of the wireless router, find the DHCP management item of the wireless router, turn off the DHCP function of the wireless router (turned on by default), restart the router and the computer after saving, and the computer wireless network card will search for wireless signals, but because the DHCP function has been turned off, the computer has not obtained an IP address, and the network connection in the lower right corner will prompt an exclamation point!

Start Ruijie, and choose Ruijie's connecting network card as your wireless network card (Note: Ruijie certification does not allow two running network cards on a machine, otherwise the current system working environment will pop up after certification, which conflicts with software operating environment and the software will not run normally! Code2 message, so disable the Ethernet card of the notebook when selecting the wireless network card) and then set the IP address in the wireless network card;

Final certification!

Finish and enjoy your wireless network! I hope it helps you.