Today, the teacher asked each of us to invent something. What should I invent? After thinking about it, I suddenly had an idea: Why not invent a truck excavator? There is not one yet! Generally It takes two vehicles - a truck and an excavator to go to the construction site together, which is too troublesome. In addition, after it rains, there must be a lot of mud on the construction site, and the truck will slip easily, so it will be difficult to keep up. I have an excavator. Wouldn’t it be much more convenient if I added a truck pocket to the back of the excavator?

I just did it. I immediately found some cardboard and some handicrafts. I started making it with paper, a pair of scissors and a roll of double-sided tape. Now, please take a look at the process of making a truck excavator!

The first step: making the front of the truck. The front of the truck is a cube. So, I took a piece of purple cardboard and made it into a small rectangle. Then, I cut a few pieces of blue handmade paper to make the car windows, and cut two small yellow circles to make the car lights. Finally, I Then use a pen to draw the door. In this way, the front end of the car is ready.

Step 2: Make the body. I made the body from a toothpaste box, but the toothpaste box was too long, so I cut it off. Finally, I wrapped the toothpaste box with yellow handmade paper. In this way, the car body is ready.

Step 3: Make the car pockets. The car pockets are actually very easy to make. Just cut the cardboard into a "convex" shape, then fold it and glue it in place.

Step 4: Make the tracks. I first cut the black cardboard into five pieces of the same size. rectangle, and then roll it into five cylinders of the same size. Finally, wrap a black cardboard strip with the same width as the cylinder on the outside, and it is ready.

Step 5: Make the excavation arm. I made the excavation arm with straws and toy forks. I first attached the four straws together to form a rectangular parallelepiped, then bent the extra section, and finally inserted two toy forks. It’s done.

The last step is to do the assembly. Attach the front of the car to the front of the body, then attach the pockets to the body, then attach the tracks to the front of the car and under the body. Finally, put the excavation The arm is fixed on the right side of the front of the car. In this way, the truck excavator is completed.

After listening to my introduction, what do you think of the truck excavator I made?