Current location - Quotes Website - Famous sayings - Correct method of binding steel bar
Correct method of binding steel bar
The correct method of binding reinforcement is as follows:

1. Take tools to the construction site.

2. Draw reinforcement points according to the drawings.

3. Draw some positions on the reinforced white road.

4. Fold the wire in half. Don't pinch to death in the middle. Leave a hole for the hook to pass through.

5. Hold the hook against the other end of the wire, rotate and tighten it.

6. Just tighten it. Never twist it all the time, or the wire will be excessively twisted.

If the technology is correct, we need to know the standard of reinforcement in order to work better. The standards of reinforcement are as follows:

The length of the first rebar connection shall not be less than 300mm.

The second minimum connection length is 25% according to the overlap ratio, and the coefficient is 1.2.

The position of the third vertical rod should be turned up to 1 m to set the rod joint.

Four, the appropriate location of vertical reinforcement is 12G90 1- 1, which is beneficial to construction and does not involve structural safety.