How to make an Ultraman card blind box is as follows:

Method 1:

1. Take out the square colored paper, fold it in half on both sides, and then fold it in half left and right , into a small square, unfold the paper, leaving creases.

2. Fold the left and right corners of the two small squares below toward the center, and in turn, align and fold the triangle upwards.

3. Fold the left and right corners of the two small squares inward one-third, then reverse the fold and fold it into a triangle along the crease.

4. Turn it over again, fold the downward corner of the square upward 3 times, and then fold the left and right corners along the crease.

5. Fold the small triangles on the left and right sides downward, and then fold the eyes downward.

6. Next, fold the two triangles on the left and right sides of the face back and then fold them outward along the drawing marks.

7. Next, fold it back and left along the center line of the nose at the same time, so that the three-dimensional Ultraman is completed.

Method 2:

1. Take a square piece of paper, fold it in half horizontally and vertically, unfold it, and fold the top two corners to the center line. In turn, fold the top corner to the bottom edge.

2. Fold the lower two corners symmetrically inward. In turn, fold the top two corners to the center point of the bottom edge.

3. Pull up the rhombus surface and fold it into 4 sections on the inside and outside. Align the left and right corners with the two waists and fold them inward.

4. Fold the two small triangles on the surface into a trapezoid. , make three creases in the middle.

5. Just fold the left and right corners inward and outward.