1. Specific production equipment: multi-function crystal imaging machine + computer + printer.

2. Scope of application: suitable for all crystal styles (including various special shapes).

3. Crystal production process:

4. Production method: printing + crystal gluing + bonding non-sanding film and curing + trimming

That is to print For good crystal film, use crystal glue to stick to the bottom of different crystals, then put it into a multi-functional crystal imaging machine for light solidification, take it out for 2 minutes and use a paper knife to trim and clean it, finally put it in and reinforce it for 3-5 minutes, take it out and tear it Remove the protective film on the crystal film, and the imaging is completed

5. Time, quality and shortcomings:

Time: ***It takes 5-8 minutes to complete. Skilled technicians can Completed in 5 minutes.

Advantages: (1) The processing equipment is lightweight (less than 3KG), low cost and small investment;

(2) Production is convenient and fast, saving 5 times the time compared to the grinding process ;

(3) No noise, no pollution, environmentally friendly and energy-saving, suitable for in-store and outdoor production;

(4) If there is a mistake in the production process, the recovery rate is 100%, and there is no crystal loss;

(5) No matter how long the customer uses it, the image can be re-produced, and the material and labor fees can be charged, and a continuous customer base is guaranteed;

(6) The effect is good, and it can be used by large and small photo studios at home and abroad, and personalized Stores are promoting its use, and the market response has been strong.

Disadvantages: (1) The surface can be cleaned, but the soaking time in warm water cannot exceed 120 hours;

(2) It can resist ordinary scratches, and strong contact with sharp objects must be avoided;