Step 1: Open the bottom cover. Step 3: Add ink to the lines of the text. Step 3: Wait for the ink to penetrate for 20-30 minutes. Step 4: Wipe off the remaining ink with a paper towel. Step 5: Wipe off the printed surface. Step 6: Stamp directly.

Atomic printing is a kind of liquid die casting, which uses special materials and modern typesetting and plate-making technology to carve the seal into a printing plate, and then the atomic oil and the printing plate are hot-pressed and cured.

Question 2: How to add printing oil to the surface of the atomic seal, then turn it upside down for half an hour, and then cover it with a few pieces of waste paper to make the ink even!

Question 3: How to add stamp oil to the surface, then turn it upside down for half an hour, wait for it to be completely absorbed, and then cover some waste paper, so that the ink can be even in a few times!

Question 4: What is the seal ink of the builder's seal? Can I add it myself? Is it atomic ink or photosensitive ink? Or what kind of infiltration? Hello, I have seen that the samples provided by customers have penetration printing and photosensitive printing, but the imported atomic printing does not, because we can't refuel any more. The prominent words on the printing surface are infiltration printing, and the words on the printing surface are flat, which can only be done if you send the pictures on the printing surface to the photosensitive printing department. Through printing is divided into engraving through printing and mechanical pressure through printing.

Question 5: How to clean the photosensitive seal with atomic ink? To be sure, you added the wrong ink. First, you carefully take out the gasket and rinse it in a container filled with anhydrous alcohol. After washing, carefully blow dry with a fan. When using the air duct, be careful not to open the electric heating gear, otherwise it will blow out the photosensitive seal and melt it. ) After drying, add the correct photosensitive printing oil. This article comes from: Guangzhou engraved seal kz020/shownews.asp? id=287

Question 6: Can the official seal of Atomic Oil be mimeographed? The official seal of atomic oil can be printed with oil.

The official seal of atomic oil should be stamped with the professional seal of atomic oil, and it is not allowed to refuel indiscriminately, otherwise it will damage the official seal.

Atomic seal belongs to modern high-tech products. It stores the ink in the inner core of the seal, and then makes the inner core into the shape of the printing surface, so that the ink oozes from the inner core every time the seal is stamped, and it is not necessary to print the ink on the printing table every time the seal is stamped, which improves the efficiency of office production.

Atomic seal printing method:

1. Pour 15ml of professional seal oil for atomic seal into a flat-bottomed vessel (the volume of the vessel is slightly larger than the size of the seal).

2. Pour the printing surface of the atomic seal into the printing oil once (leave it for about 12 hours).

3. After the ink is absorbed by the seal, take it out and wipe off the excess ink around the seal with a paper towel.

Question 7: How to add atomic chapter seal oil? Remove the cover of the atomic seal and lay it flat on the table. Drop ink on the surface of the seal. Just wear the seal and it's ok.

Can be added repeatedly for many times, and the effect is better.

Ps: Don't cover the surface layer too much at a time. Experts can provide: