Current location - Quotes Website - Signature design - How does the magic of putting coins in glass bottles work?
How does the magic of putting coins in glass bottles work?
The following is the teaching of putting coins into bottles, which is the same as the principle of putting bottle caps into bottles ... Let's start with the following points: 1. Props: 2 one-dollar coins, plastic coca-cola bottle 1, an art knife, a small magnet 1 (the magnetic force is strong enough, mine is removed from Desheng radio headset, and the effect is very good), and the ring 1 (if you). No need to prepare a small magnet) 2. Prop handling: As shown in figure 1, carefully tear the trademark of the coke bottle along the seam, cut a small mouth along the seam with a utility knife to insert coins, and then affix the trademark. Third, wear a ring on the middle finger of the left hand and insert a small magnet in the gap between the ring and the finger. As shown in figures 2 and 3. Props are ready. The following is the performance method: performance steps: 1 Hold the coin in the bottle at the trademark with your left hand, and attract it to the trademark with a magnet to show the audience that the bottle looks empty because the coin is blocked by the trademark and the hand. As shown in figure 4. Take out another coin with your right hand and show the audience that it is impossible to insert a coin from the bottle mouth. Then put the coin in the palm of your hand and cover the bottle mouth with force. At this time, the coin will collide with the bottle mouth and make a "bang". At this time, immediately keep the left hand ring away from the bottle, or rely on the impact force to make the coin originally adsorbed on the back of the trademark fall to the bottom of the bottle. There is still a coin in the right hand. Keep hiding in your hand and give the bottle to the audience for inspection. Then tell the audience to take out the coins. Turn the bottle upside down, with the trademark still in the left hand (ring) and the bottle mouth in the right hand. Try not to leave a gap between your hands (as shown in Figures 5 and 6). Shake the bottle gently to make the magnet attract the coin again (shaking at this time will make the audience mistakenly think that the magician is looking for a place to let the coin out). At this time, open your right hand to show the coin, and then hold the bottle vertically to make the audience think that the coin has been taken out. Before the audience asks for inspection, "change" the coins immediately, and then let the audience inspect the goods. At this time, the coins in the right hand should be hidden in the trouser pocket. The performance is over. Pay attention to details: 1 Be sure to cut the bottle along the seam of the trademark, which is slightly longer than the coin. In the performance, the trademark should always be in a horizontal line with the audience's eyes. The water in the bottle doesn't need to evaporate completely. Leave a little in it to make the inner wall of the bottle feel a little foggy, which makes it more difficult for the audience to find the "wound" of the bottle. 4 Right-handed coins should be hidden naturally. More contact with the step of "taking out" is the difficulty of the whole magic and the key to success. Finally, I wish you success! I will also send you some video addresses to show you many methods/videos/Zong Yi/2007-05-25/350811.html.