Legal analysis
If the flow rate is far below the minimum flow rate to ensure accuracy, there will be no output (such as vortex flowmeter) or the output signal will be cut off as a small signal (such as differential pressure flowmeter), which is unfavorable and unfair to suppliers. In order to prevent the loss of benefits, for a specific set of thermal energy metering equipment, the supply and demand sides often agree that a certain flow value is the "agreed lower limit flow" according to the flow measurement range and the achievable range, and agree that if the actual flow is less than the agreed value, it will be charged according to the lower limit flow. The metrological administrative department of the people's government at or above the county level may set up metrological verification institutions according to needs, or authorize metrological verification institutions of other units to perform compulsory verification and other verification and testing tasks. Personnel who perform the verification and testing tasks specified in the preceding paragraph must pass the examination. This function is usually realized in the flow display instrument. The metrological administrative department of the local people's government at or above the county level shall, according to the needs of the local area, establish public standard instruments of measurement, which shall be used after passing the examination presided over by the metrological administrative department of the people's government at a higher level. Enterprises and institutions may, as required, establish standards of measurement for their own use, and the highest standards of measurement shall be used after passing the examination presided over by the metrological administrative department of the relevant people's government. Metrological verification shall be carried out on site in accordance with the principle of economy and rationality. Metrological verification must be carried out in accordance with the national metrological verification system table. The national metrological verification system table shall be formulated by the metrological administrative department of the State Council.
legal ground
Regulations on the administration of housing provident fund
Article 24 Under any of the following circumstances, employees may withdraw the storage balance in the employee housing provident fund account: (1) purchasing, building, renovating or overhauling their own houses; (2) retirement; (three) completely lose the ability to work, and terminate the labor relationship with the unit; (4) Having left the country to settle down; (5) Repaying the principal and interest of the house purchase loan; (six) the rent exceeds the prescribed proportion of family wage income. In accordance with the provisions of items (2), (3) and (4) of the preceding paragraph, the employee housing provident fund account shall be cancelled at the same time. If an employee dies or is declared dead, the employee's heirs and legatees may withdraw the storage balance in the employee's housing provident fund account; If there is no heir or legatee, the storage balance in the employee housing provident fund account shall be included in the value-added income of the housing provident fund.
Twenty-fifth workers from the housing provident fund account balance, the unit shall verify, and issue a certificate of extraction. Workers apply to the housing provident fund management center for withdrawal of housing provident fund with the withdrawal certificate. The housing provident fund management center shall, within 3 days from the date of accepting the application, make a decision on whether to approve or disapprove the withdrawal, and notify the applicant; If the withdrawal is approved, the entrusted bank shall go through the payment procedures.