1. Open the eNSP simulator, select the switch, drag S5700 to the topology diagram, select the switch, then open the device, and then enter the configuration interface.

2. Create a vlan. Specific commands are as follows:

& lt Huawei & gt[ system copy command (short for system)

Enter the system view and use Ctrl+Z to return to the user view.

[Huawei] System R2 Company

[R2] Deactivate information

Information: The information center is disabled.

[R2]vlan 10

[R2-vlan 10]

3. After creating the vlan, use the dispaly vlan command to view the relevant information of the vlan. [R2] Displays the virtual local area network.

4. Then use the port link access command to configure some interfaces with access modes on the switch, use the port default vlan command to configure the default VLAN of the interfaces, and add the corresponding VLANs at the same time.

After the configuration is completed, check whether the VLAN information successfully added the port to VLAN 10.