Current location - Quotes Website - Team slogan - How to set the network speed of Tuoshi router to make it faster?
How to set the network speed of Tuoshi router to make it faster?
XP/WIN7 system will limit the network speed by 20% by default. We can easily lift this restriction, so that your surfing speed can reach 100%, and truly experience the feeling of surfing. The method is as follows: Start menu-Run-enter ""gpedit.msc "",as shown in the figure.

The following window will appear. Click Computer Configuration, as shown.

Click the management module again, as shown.

As shown in the figure, click Network again.

As shown in the figure, click QoS Packet Scheduler again.

Click Restrict to Keep Broadband again, as shown in the figure.

Select Enable to change 20 to 0, as shown in the figure. Press Apply and then OK, hehe! Is it much faster?

First take the connected wifi out of the phone, that is, choose not to save it (different versions display differently). Enter IE192.168.1to enter the control panel of the router, and select the setup wizard modification mode. Generally, the default value is 1 1bgn.

The method of setting the router to slow down and speed up is as follows: 1. Open a browser, enter the general IP of the router "192.168.1"and press enter.

Pop up an input port, and enter the account number and password. Usually, the account and password of all routers are admin. If not, you can also check them at the bottom of the router.

Enter the router and find DHCP in the list on the left.

Click the client list in the DHCP column to view all clients connected to the router and copy the MAC address and IP address into it.

Then click the static address assignment in the DHCP column, paste the MAC address and IP address of a single client, and select Effective.

Repeat this step and enter the MAC addresses and IP addresses of all clients connected to the router accordingly.

Next, select IP Broadband Control in the list on the left, and select a new column at the bottom of the page.

Enter the IP start address and IP end address of each client accordingly. If you only need to control the broadband of one client, the IP start address and IP end address are the same.

Enter the broadband range to be controlled by each client. Repeat all clients.

Click to open IP to control broadband, and finally save, you can use the router to control the speed of the network.