Suggest TL? WR340G+？ Connect broadband, because the bridging function of this model does not support WPA-PSK/WPA2-PSK? AES encryption algorithm, unsafe. Wds function is generally an upgraded version of bridge, which supports such advanced algorithms.

Need equipment:

1. A network cable exceeding Category 5.

2. A wired network card computer with xp operating system.

3. Several power supplies

4. Computer (notebook) with wireless network card.

Operating steps:

1. Wired connection? Router TL? WR340G+？ According to the instructions, access wlan, start DHCP service and wireless function, and set the "network parameters-LAN port address" of 340G+ to 192. 168. 1.

2. Set the 340G+ wireless channel to a fixed value, such as channel 13.

3. Set the wireless access encryption mode and password as required.

4. Obtain 340G+ signal parameters, including? SSID？ , mac address (Note: Wireless MAC address is generally the same as wired LAN? Mac address is the same), password, encryption method.

5. Wired connection? Router KN-WR932 1 1N? , turn off the DHCP service, turn on the WDS mode, set the same channel as 340G+, such as channel 13, and set the "network parameters-LAN port address" of KN-WR932 to 192.438+068.6438+0.2.

6. If you have the function of "scanning" wireless signals, please click "Scan" to obtain signal parameters. If not, fill in the parameters obtained in step 4.

7. Wait? The connection was successful. The message "WDS Status: Success" is displayed.