1) Touch the button (as shown in the figure below). After the user switches the pop-up interface, the button is marked as the current driving mode and can be associated with the key.

2) Touch the button (as shown in the figure below) to open the following pop-up interface.

Note: Touch three buttons (as shown in the figure below), and the operations are back, delete signature and save signature in turn.

3) Touch (as shown below) voiceprint management to enter voiceprint.

After entering the voiceprint, step on the brake or clutch pedal in P gear or neutral gear to wake up "Hello Xiao An". After Xiao An responded, the voice "start the vehicle" completed the voiceprint to start the vehicle.

4) Slide the button left and right (as shown in the figure below) to switch the information of different drivers and guests.

5) Touch the button (as shown in the figure below) to open the following interface:

Note: Touch the button (as shown in the figure below) to jump to the setting interface;

Touch the button (as shown in the figure below) to jump to the vehicle setting interface.

Prompt bar at the top of the interface

: Wi-Fi connection prompt, which is displayed when WiFi is turned on, and also shows the signal strength.

: Bluetooth connection prompt, which is displayed when Bluetooth is turned on, and the connection status is also displayed.

: Power prompt, which displays the remaining power in the prompt bar.

Drop-down menu interface

The drop-down status bar will display the drop-down menu interface. Hold down the button (as shown in the figure below) and drag it up to close the drop-down menu interface. The drop-down menu has two interfaces: switch and information.

The switch menu can quickly operate the switch state of WiFi and Bluetooth, or directly set the volume and brightness.

Note: "Navigation Volume" only appears when the navigation function is installed, and the navigation function is optional.