2. RSD of the brush platform (see also this area), and a blue icon will appear after the installation.

3. Brush package that suits you.

According to personal requirements, some people want speed, some people want multifunction, and some people want system stability.

Ok, let's talk about the brushing steps first, but it's best to ensure that the battery is fully charged before brushing, and at worst, there should be two batteries, otherwise the power may suddenly cut off and the machine will not start (it's too late to cry).

1. Brush-in mode: first turn off the phone, then press and hold the * (meters or stars are called differently) key and the # key with two fingers, and press the On/Key again at the same time (it takes several seconds, so be sure to press and hold the three keys at the same time). When the following English is displayed on the screen, you have successfully entered the brush mode.

Boot loader

XX。 XX (XX。 XX is the version number of your boot loader)

The battery is normal

It can be programmed.

Connect USB

data cable

2. Brush the bootloader package: check whether the numbers in XX are. XX (XX is the version number of your bootloader) is 0905. If it is lower than 0905, you have to upgrade the bootloader to 0905. You can download the bootloader0905 package below, and then click RSD to brush the machine platform. As shown in the figure below, click the ellipsis to find bootloader0905.sbf

Then click the Start button, as shown in the figure below. Brush quickly, it will be finished in a few minutes.

During the brushing process, the percentage progress will always run, as shown in the following figure.

In the process of brushing, the percentage progress will always run, as shown in the figure below.

Until a prompt says that the phone is powered on or displayed, the phone icon turns green, which means that bootloader0905 is complete. At this point, you can turn off RSD and unplug the data cable ().

3. Brush NoRSA (to cancel the digital signature, you must brush it before brushing the machine, but it is enough to brush the mobile phone 1 time, and it will be effective in the future, and you don't need to brush other packages). Steps are the same as above.

4. Brush the machine package (or brush the Bootloader on it), and remember to empty it after brushing (password 000000).

Bootloader and NoRSA are downloaded here:/thread-597375-1-1.html.

Brush tools and drivers can be downloaded here:/thread-531699-1-1.html.

Pay attention to the brush package of EM35 and VE66. Booloader and NoRSA cannot brush each other. Please find one suitable for your mobile phone.

Brief process:

1. Download and install the computer driver and brush program.

2. Turn it off first, press * and # and then turn it on, and see what the current bootloader is under 1, usually 0900 or 0905.

If bootloader is 0905, skip to step 4.

3. brush bootloader 0905.

Brush NoRSA

Brush bag

6. main reset (go to phone settings > reset > delete all data, preset code is 000000), and restart automatically after main reset.

7. After restarting, please manually press the on-hook key to turn it off and then restart. After restarting, you can use mgx programs and mgs themes.

/thread-582867- 1- 1 . html