(1) Plane System Method (Europe)

1. Thread the toe strap from the bottom (gray part) directly into the two shoe holes at the bottom.

2. One end of the shoelace (yellow end) goes out obliquely from bottom to top and directly enters another shoe hole in the second horizontal row.

3. The other end of the shoelace (blue end) diagonally passes through the third row of shoe holes from bottom to top, and goes straight into another shoe hole.

4. Repeat the operation, and the two shoes lead alternately.

(2) rope ladder method

1. Insert the toe cap from the bottom (gray part) through the two holes at the bottom.

2. Both ends of shoelaces are aligned upwards and pass through the second row of shoe holes.

3. Before threading the shoelaces upward into the next row of holes, cross the shoelaces and vertically thread them from the bottom of the shoelaces on the other side.

4. In the top hole, the two shoelaces cross again, pass under the vertical part, and then fasten.

(3) Method of displaying shoe system (triathlon T 1)

1. Thread the toe strap from the bottom (gray part) directly into (rather than out of) the two shoe holes at the bottom.

2. Pass through the toe cap, and then pass through the second row of shoe holes again.

3. Repeat this process until the shoelace passes through the upper two holes (from the inside of the shoe).

According to the normal tying method above, put the shoelaces through and tie them behind the tongue. Or, after tying the shoelace, tighten the button down to make a little gap, turn the button over and press the shoelace under the button.