Legal analysis

If the flow rate is far below the minimum flow rate to ensure accuracy, there will be no output (such as vortex flowmeter) or the output signal will be cut off as a small signal (such as differential pressure flowmeter), which is unfavorable and unfair to suppliers. In order to prevent the loss of benefits, for a specific set of thermal energy metering equipment, the supply and demand sides often agree that a certain flow value is the "agreed lower limit flow" according to the flow measurement range and the achievable range, and agree that if the actual flow is less than the agreed value, it will be charged according to the lower limit flow. The metrological administrative department of the people's government at or above the county level may set up metrological verification institutions according to needs, or authorize metrological verification institutions of other units to perform compulsory verification and other verification and testing tasks. Personnel who perform the verification and testing tasks specified in the preceding paragraph must pass the examination. This function is usually realized in the flow display instrument. The metrological administrative department of the local people's government at or above the county level shall, according to the needs of the local area, establish public standard instruments of measurement, which shall be used after passing the examination presided over by the metrological administrative department of the people's government at a higher level. Enterprises and institutions may, as required, establish standards of measurement for their own use, and the highest standards of measurement shall be used after passing the examination presided over by the metrological administrative department of the relevant people's government. Metrological verification shall be carried out on site in accordance with the principle of economy and rationality. Metrological verification must be carried out in accordance with the national metrological verification system table. The national metrological verification system table shall be formulated by the metrological administrative department of the State Council.

legal ground

Article 59 of the Civil Procedure Law of People's Republic of China (PRC) * * * entrusts others to represent the litigation, and a power of attorney signed or sealed by the client must be submitted to the people's court. The power of attorney must specify the entrusted matters and authority. An agent ad litem must have the special authorization of the client, and can admit, waive or change the claim, make a settlement, file a counterclaim or appeal on his behalf. The power of attorney sent or entrusted by China * * and China citizens living abroad must be authenticated by China * * and China's embassy or consulate in that country; If there is no embassy or consulate, it shall be certified by the embassy or consulate of a third country that has diplomatic relations with the people of China, and then by the people of China and the embassy or consulate of China in a third country, or by the local patriotic overseas Chinese delegation.