In the driving test, Subject 2 should be said to be more difficult. Of course, if you know all the skills and are proficient in driving, none of them will be difficult. This is just a relative term. Below I will tell you what you should pay attention to when taking the subject test. ? Method/Step 1 First of all, you must prepare yourself before the exam,
(1) If it is winter, do not wear too thick cotton clothes, as it will be inconvenient to wear a seat belt,
(2) Adjust your mental state, don’t be nervous, just treat it as a training session for yourself.
(3) Remember your sequence number correctly. When it is your turn, the examiner will only call your number but not your name.
(4) Prepare a pair of sports shoes or flat shoes that are more comfortable for you. 2. Before starting the test, shout a report to the examiner before getting on the bus. This is a sign of respect for the examiner. Of course, in general The examiner will not deduct your marks because of this. This is just a matter of etiquette. Just pay attention to it. 3. After getting in the car, you should pay attention to several issues:
(1) Adjust your driving posture and seat first.
(2) Adjust the rearview mirrors on both sides. I have introduced it in the previous sections to the position that suits you and to what extent. You can take a look in my space.
(3) Fasten your seat belt. This is very important. If you don’t fasten your seat belt, you will fail the test. Also be careful not to wear your seat belt backwards.
(4) After all the preparations are done, wait until the examiner calls for the exam to begin. If someone is sitting in the car, follow her instructions. If you are not sitting in the car, someone will remind you that the test has started. ?4 Start the test: Pay attention to the following steps:
(1) First depress the clutch, shift to 1st gear, turn on the left turn signal, press the horn, release the handbrake, and then slowly release the clutch. Move forward slowly,
(2) Reverse the car into the warehouse at the first level. When the car reaches the test area, the speaker in the car will remind you that "the reversing car into the warehouse test begins" 5 Things to note when reversing the car into the warehouse:
(1) When the car reaches the starting position, the distance between the body and the line should be pressed against the white line on the right front of the garage, but not beyond.
(2) When reversing, you should pay attention to the alignment point and hit the direction. How you usually practice is still the same as the test now. Look at the alignment point in the rearview mirror.
(3) After entering the garage, the car must be straightened and do not turn left or right.
(4) Be careful not to pour too much after entering the warehouse. Stop as soon as you enter the warehouse.
(5) When leaving the warehouse on the left, pay attention to the distance between the left car body and the warehouse line. size, adjust the steering wheel appropriately,
(6) When exiting the warehouse on the left, you must exit the warehouse to the specified position,
(7) Do not stop or roll away during the entire process. Can't shift gears, can't turn off the engine, can't shadow the line. (Some lines cannot be crossed) 6. Notes on side parking:
(1) When the car drives to the test position, the vehicle body cannot exceed the white line, that is, the vehicle body cannot press the white line.
(2) The distance between the car body and the edge of the garage should be adjusted, as well as the distance between the body and the garage. It should not be too close to the garage. At least the rear wheels of the car should exceed the edge line of the garage.
(3) Look at the alignment when turning.
(4) Turn left and sound the horn after entering the garage. When leaving the garage, the vehicle must not hit the corner of the garage.
(5) During the entire process, you cannot stop, roll away, shift gears, stall, or cross the line. (Parts cannot cross the line) 7 Notes on right-angle turns:
(1) When the car moves forward, the distance between the body and the right edge line must be adjusted,
(2) Wait until the car arrives When cornering, hit the steering wheel according to the speed of the vehicle.
(3) After being killed, you can stretch your head to see if the left rear wheel of your car can press the corner. If it can, you can turn the steering wheel appropriately.
(4) During the entire process, you cannot stop, roll away, shift gears, stall, or cross the line. 8 Precautions for fixed-point hill climbing and starting:
(1) When driving uphill, turn right and do not drive too fast. Generally, it is appropriate for the right wheel of a car to be 30 centimeters from the edge line.
Control this distance.
(2) When reaching the specified position, the vehicle speed should be slower, so that the point can be found more accurately.
(3) Before starting, turn left, sound the horn, and find the semi-linkage. Generally don't press the gas pedal.
(4) During the entire process, you cannot stop (except at fixed points), roll away, shift gears, stall, or cross the line 9. Precautions for curve driving:
(1 ) The car needs to make a big turn after entering the curve.
(2) The speed of the vehicle should be controlled slowly and it is best to move forward at a constant speed. Every corner must be pointed accurately, the direction must be turned fast, and the return turn must be fast.
(3) During the whole process, you cannot stop, roll away, shift gears, turn off the engine, or press the line. 10. After the test, drive the car to the starting position, that is, where you drove it. Drive wherever you go without turning off the engine. After the exam is over, you should not leave the exam room until you have signed to confirm your score. After the results are confirmed, all the work for subject two is over.