I. Usage

When in use, the user first inputs the required characters through the graphics editing and processing software installed in the computer and matched with the engraving machine, and sets the required font and size, or makes the required graphics. After completing the design of the required engraving content, the user can send instructions to the engraving machine through the computer. The engraving knife controlled by computer and driven by engraving machine engraves the characters and images that have been designed on the computer on the carvings (usually post-it notes and plastic films). Engraving machines can also be used to cut paper or carve materials on thin metal paper.

Second, the installation

The installation steps of the engraving machine are as follows:

This picture is provided by the registered user "Orange Palace", and the copyright statement is feedback.

1. Unpack the packing box, and clean the fixing tape and anti-collision objects of the car of the engraving machine first;

2. Connect the engraving machine and the power socket with the attached power cord;

3. Connect the engraving machine and computer with the communication cable provided randomly;

4. Insert the tool holder or pen holder into the tool holder of the engraving machine, and tighten and fix the tool holder or pen holder;

5. Turn on the power supply;

6. Place the medium and put down the press wheel (note: the position of the press wheel should be at the edge of the medium and ensure that the position does not deviate from the work area);

7. Set parameters (computer settings: a, select the model; B, select the port and set the traffic mode. Setting of engraving machine: a, setting coordinate origin; B, adjust the tool depth, etc. );

8. Self-inspection test of engraving machine;

9. Test the engraving machine by transmitting data through the computer, and it will be ready if it can output normally.